Re: Sheevaplug will not finish booting after kernel update
Le 25/10/2010 20:18, Jason Graham a écrit :
> On Mon, Oct 25, 2010 at 11:15:20AM -0700, Jason Graham wrote:
>> Hi,
>>
>> I'm running a Sheevaplug on Debian Lenny. This morning I updated the
>> kernel to the one that was released today, and afterwards my
>> Sheevaplug would not finish booting. In retrospect, I realize I
>> forgot to run `flash-kernel` after upgrading, but I don't think this
>> is the root issue, since I have forgot this step in the past, and the
>> machine would just reboot into the previous kernel, at which point I
>> could correct my mistake and reboot again.
>>
>> I connected via the USB-serial port, and watched it run through the
>> drive checks (I had to disconnect the power to move it over to my main
>> machine, causing the USB hard drive to not be unmounted properly) and
>> then freeze afterwards.
>>
>> At this points, I connected the hard drive to my desktop machine to
>> back-up my data, used GParted to check the disk integrity and cause
>> the disk to believe it had been properly unmounted, and reconnected it
>> to my plug.
>>
>> After several reboots of the plug, I keep getting dropped into the
>> BusyBox shell, and I cannot figure out the error.
>>
>> My plug is configured as described by Martin Michlmayr on his website
>> [1]. I have attached a boot log, which contains a printout of the
>> `printenv` command.
>>
>> [1]:http://www.cyrius.com/debian/kirkwood/sheevaplug/unpack.html
>>
>
> I forgot my attachment.
>
take care of this :
> mount: mounting /dev/sda2 on /root failed: No such device
> ...
> mount: mounting /sys on /root/sys failed: No such file or directory
> mount: mounting /proc on /root/proc failed: No such file or directory
Is your /etc/fstab correct ?
Your log show this too :
> mdadm: No arrays found in config file or automatically
>
> Failure: failed to assemble all arrays.
Do you have made a raid installation ?
--
"Look on the other side for address and phone"
-- P. K. Dick
Reply to: