Re: Problems installing Etch on NSLU2
* Davide Viti <firstname.lastname@example.org> [2007-05-15 20:49]:
> I then re-flashed the original firmware from linksys via Redboot,
> restored factory defaults and flashed the d-i image using upslug2:
> everything went fine and after rebooting the device beeps after ~3
> minutes (not 7-10 minutes like explained in tbm pages). Again, I
> cannot reach the nslu (no ping, no ssh).
This is strange because, if it pings, the network has been configured
(properly?). Have you used a static IP configuration? If so, maybe
there was a typo or something? If you have used DHCP, can you check
the DHCP server logs?