On Sun, Mar 25, 2001 at 02:33:56PM +0530, Harishankkar wrote:
> we have downloaded the linux kernel to the assabet .We have
> followed the instructions in the web site
> .We got the linux penguin image on the LCD since we have included the
> buffer support in the kernel.
> After this we get the D8 LED constantly blinking.What does this
> this mean that we have loaded linux properly.
> Now then we tried the RAM disk image that is given in the site.
> After downloading the kernel only the TUX image in the LCD screen
> minicom gets started up and no messages
> on the serial port,what could be the problem?. We have configured
> for 9600 8 bits 1 stop bit.Is it possible to
> get a login prompt in the serial Port?We are using the angelboot
> utility for
> linux as the host program fro downloading.
> When we tried to make a RAMDISK on our own we got a message in the
> Mount root file system(ext2)64 K freed
> Kernel Panic:init not found
> It did not say anything on RAM DISK initialised.
> what could be the problem?
> Is it possible to single step the code ?I am having only the assabet
> only .
This is not debian-arm related. I suggest to take this question to the
linux-arm or sa1100-linux list. See http://www.lart.tudelft.nl/doc.php3
for mailing list addresses.
J.A.K. (Erik) Mouw, Information and Communication Theory Group, Department
of Electrical Engineering, Faculty of Information Technology and Systems,
Delft University of Technology, PO BOX 5031, 2600 GA Delft, The Netherlands
Phone: +31-15-2783635 Fax: +31-15-2781843 Email: J.A.K.Mouw@its.tudelft.nl
- From: "Harishankkar" <S.firstname.lastname@example.org>