Re: fujitsu-siemens primergy rx300 s2
I now have eth0 not configured anymore, and have manually configured eth1,
so the normal is switched from what it was at install. Check to see what
the hardware address is, and if need be, specify eth1 on the ifconfig
commandline.
cwevans@debian:~$ /sbin/ifconfig
eth1 Link encap:Ethernet HWaddr 00:01:29:FE:6B:2F
inet addr:192.168.1.10 Bcast:192.168.1.255 Mask:255.255.255.0
inet6 addr: fe80::201:29ff:fefe:6b2f/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:2433146 errors:0 dropped:0 overruns:0 frame:0
TX packets:2729674 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:378131965 (360.6 MiB) TX bytes:2003398860 (1.8 GiB)
Interrupt:21 Base address:0xe000
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:170 errors:0 dropped:0 overruns:0 frame:0
TX packets:170 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:113636 (110.9 KiB) TX bytes:113636 (110.9 KiB)
cwevans@debian:~$ /sbin/ifconfig eth0
eth0 Link encap:UNSPEC HWaddr
00-01-29-20-00-01-79-21-00-00-00-00-00-00-00-00
BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
On 3/24/05 3:41 PM, "dr.bob" <dr.bobik@gmail.com> wrote:
> On Thu, 24 Mar 2005 14:41:17 -0800, Chris Evans
> <cwevans@thesae.k12.ca.us> wrote:
>> Just out of curiosity, does the motherboard have onboard ieee1394?
>>
>> My board had it, and it probed that as eth0, which will normally not be used
>> for networking. But I could bring eth1 up with the onboard gigabit from my
>> nforce3 board.
>
> I don't think so (I most likely won't be near that box until tuesday
> or wednesday).
> It has two BCM5700 that were detected by the netinstall which loaded tg3.ko to
> handle them.
>
Reply to: