Re: aic7 vs sym53c8
On Sun, Nov 11, 2001 at 02:50:09PM -0500, Tom Vier wrote:
> i'm looking to buy a u2w card, and i'm split between an adaptec and a tekram
> the sym53c8 driver doesn't like > 8 tcq depth, but other than that, i
> haven't had any problems. does the aic7 driver work correctly on alpha?
> anyone else have > 8 tcq depth problems on a pws x00?
>
Linux version 2.4.13-ac8 (root@alpha) (gcc version 2.95.4 20011006 (Debian prerelease)) #1 Fri Nov 9 14:18:35 CET 2001
Booting on Miata using machine vector Miata from SRM
SCSI subsystem driver Revision: 1.00
sym.2.0.0: setting PCI_COMMAND_INVALIDATE.
sym.2.1.0: setting PCI_COMMAND_INVALIDATE.
sym0: <875> rev 0x4 on pci bus 2 device 0 function 0 irq 40
sym0: Symbios NVRAM, ID 7, Fast-20, SE, parity checking
sym0: open drain IRQ line driver, using on-chip SRAM
sym0: using LOAD/STORE-based firmware.
sym0: SCAN FOR LUNS disabled for targets 0 1.
sym0: SCSI BUS has been reset.
sym1: <875> rev 0x4 on pci bus 2 device 1 function 0 irq 41
sym1: Symbios NVRAM, ID 7, Fast-20, SE, parity checking
sym1: open drain IRQ line driver, using on-chip SRAM
sym1: using LOAD/STORE-based firmware.
sym1: SCAN FOR LUNS disabled for targets 0 1.
sym1: SCSI BUS has been reset.
scsi0 : sym-2.1.16a
scsi1 : sym-2.1.16a
Vendor: DEC Model: RRD45 (C) DEC Rev: 1645
Type: CD-ROM ANSI SCSI revision: 02
Vendor: IBM Model: DDRS-39130WS Rev: HP01
Type: Direct-Access ANSI SCSI revision: 02
Vendor: IBM Model: DPSS-336950N Rev: S96H
Type: Direct-Access ANSI SCSI revision: 03
sym1:3:0: tagged command queuing enabled, command queue depth 64.
sym1:12:0: tagged command queuing enabled, command queue depth 64.
Attached scsi disk sda at scsi1, channel 0, id 3, lun 0
Attached scsi disk sdb at scsi1, channel 0, id 12, lun 0
sym1:3: FAST-20 WIDE SCSI 40.0 MB/s ST (50.0 ns, offset 15)
SCSI device sda: 17773524 512-byte hdwr sectors (9100 MB)
sda: sda1 sda2
sym1:12: FAST-20 WIDE SCSI 40.0 MB/s ST (50.0 ns, offset 16)
SCSI device sdb: 72170880 512-byte hdwr sectors (36951 MB)
sdb: sdb1 sdb2 sdb3 < sdb5 sdb6 > sdb4
Attached scsi CD-ROM sr0 at scsi0, channel 0, id 3, lun 0
sym0:3: FAST-5 SCSI 4.2 MB/s ST (236.0 ns, offset 16)
sr0: scsi-1 drive
Uniform CD-ROM driver Revision: 3.12
Nope, can't say I have any trouble.
Good luck,
Jurriaan
--
Cause I'll show you the cure
I'm gonna take away the questions
Yeah I'm gonna make you sure
Queensryche - Operation Mindcrime
GNU/Linux 2.4.13-ac8 on Debian/Alpha 64-bits 988 bogomips load:2.86 1.75 0.69
Reply to: