Troubles with a 21143 network controller
Happy new year to everyone !
I have some troubles to use my PWS500 on a 100 baseTX network.
Under SRM, I have forced the network card to use the FastFD mode. But
when the kernel boot up, the card switches to 10 baseT/Full duplex mode.
Following, there is some logs :
Under SRM, the 'sh conf' command says :
>Digital Semiconductor 21143 Network Controller
> ewa0.0.0.3.0
and 'sh ewa0_mode' says :
> ewa0_mode FASTFD
'dmesg' says :
>tulip.c:v0.91g-ppc 7/16/99 becker@cesdis.gsfc.nasa.gov
>eth0: Digital DS21143 Tulip rev 48 at 0x8000, 00:00:F8:76:40:75, IRQ 24.
>eth0: EEPROM default media type Autosense.
>eth0: Index #0 - Media 10baseT (#0) described by a 21142 Serial PHY (2) block.
>eth0: Index #1 - Media 10baseT-FD (#4) described by a 21142 Serial PHY (2) block.
>eth0: Index #2 - Media 10base2 (#1) described by a 21142 Serial PHY (2) block.
>eth0: Index #3 - Media AUI (#2) described by a 21142 Serial PHY (2) block.
>eth0: Index #4 - Media MII (#11) described by a 21142 MII PHY (3) block.
>eth0: MII transceiver #5 config 2100 status 784b advertising 01e1.
>eth0: Advertising 0061 on PHY 5, previously advertising 01e1.
>eth0: Advertising 0061 (to advertise is 0060).
>eth1: region already allocated at 0x8000.
>(...)
>eth0: Setting full-duplex based on MII#5 link partner capability of 41e1.
If someone has an idea ?
Thanks...
Pierre
--
............................................................................
.Pierre ROUSSEL . roussel@cena.fr .
. . .
.Centre d'Etudes de la Navigation Aerienne . .
.Division Support Informatique et Développement . Phone: 01 69 57 64 33 .
.Orly Sud 205 . Fax: 01 69 57 63 52 .
.94542 ORLY AEROGARE CEDEX, FRANCE . .
............................................................................
Reply to: