Re: Debian 11 unofficial firmware first installation
It could have been seen and gas lighted.
On Wed, 18 Aug 2021, D.J.J. Ring, Jr. wrote:
> Not being to log in as a user into the graphical user interface and being
> inaccessible to visually impaired users who have more than one sound card,
> makes it a fail as far as I can tell.
> Too bad they didn't see my message about RC3 failures that I sent.
>
> Best wishes,
>
> David
>
> On Wed, Aug 18, 2021 at 11:02 AM Jude DaShiell <jdashiel@panix.com> wrote:
>
> > Debian thought they hit the bullseye with this one, likely the range would
> > score this one as a 9.
> >
> >
> > On Wed, 18 Aug 2021, D.J.J. Ring, Jr. wrote:
> >
> > > I sent a message to the group that the Release of Bullseye has two big
> > > problems.
> > >
> > > 1.) You cannot log into MATE as a regular user.
> > > 2.) The sound card detection and selection dialog is broken because there
> > > is no sound to hear to verify which sound card works. If you know they
> > your
> > > sound card is the last one detected, just wait a few seconds and press
> > > enter. You'll have to finish the accessible installation WITHOUT sound
> > but
> > > when you boot up you'll have sound.
> > >
> > > But you cannot log into MATE, you can type your username and password,
> > > press enter, but something crashes and you return to the put in your
> > > username step and it's an infinite loop, happening over and over if you
> > > type in the information.
> > >
> > > You can go to console 2 and use the computer as a command line computer,
> > it
> > > will be connected to the connection you used to install.
> > >
> > > But GUI doesn't work as a regular user.
> > >
> > > Something similar happened with the release of Buster several years ago,
> > > but the next released version fixed it.
> > >
> > > Wait for the next version, hopefully the next version will fix this
> > problem.
> > >
> > > Best wishes,
> > >
> > > David
> > >
> > > On Wed, Aug 18, 2021, 08:36 Pawel L. <pltechmail@gmail.com> wrote:
> > >
> > > > Hi,
> > > > The Speakup volume is extremely low during the installation process.
> > > > In the graphical environment, after login, I have no speech and my
> > > > Braille display shows only 'Window without name" message.
> > > > No issues within the console so far.
> > > > Any fix for the graphical environment, please?
> > > > I tried the alt+F2 and typed in 'orca -r' with no luck, the 'Window
> > > > without name' message comes back.
> > > > Thank you for any suggestions.
> > > > Pawel
> > > >
> > >
> >
>
Reply to: