[Date Prev][Date Next] [Thread Prev][Thread Next] [Date Index] [Thread Index]

Re: debian-buster-di-alpha2-x86_64 standard system install

On 2/6/2018 6:53 AM, Jude DaShiell wrote:
I ran the integrity check on the debian install menu.  The last question I was asked was if system was set to utc or localtime and I answered that question and the disk went to 61% and ejected. 



So clearly Debian is not fully installed.
You should try rescue mode to repair it and report this as a bug.

From:

https://www.debian.org/devel/debian-installer/
"After using the Debian-Installer, please send us an installation report, even if there weren't any problems." 


On Tue, 6 Feb 2018, john doe wrote:


Date: Tue, 6 Feb 2018 00:49:13
From: john doe <johndoe65534@mail.com>
To: debian-accessibility@lists.debian.org
Subject: Re: debian-buster-di-alpha2-x86_64 standard system install
Resent-Date: Tue,  6 Feb 2018 05:49:28 +0000 (UTC)
Resent-From: debian-accessibility@lists.debian.org

On 2/5/2018 2:14 PM, Jude DaShiell wrote:

 The debian boot disk already had ejected at 61% of finishing the
 installation there was no way missing components could have been installed  under those circumstances unless I put the boot disk back in and waited.?  I have two systems here but have never tried an in-house ping since I am  in a wifi required situation and only have one wifi adapter, so that can't  be done.? By standard system when software selection came up I chose only 
 option 12 and none of the other defaults which normally would start the
 system out with only a command line 

After which step did it stop at 61%?
If you use rescue mode can you repair your system?
I can't test the installation process using an optical media but it looks to me as if Debian is not properly installed.
When you say that you have verified the  iso; I'm asuming that the checksum is correct (the output should end with 'OK')? 


 On Mon, 5 Feb 2018, john doe wrote:


 Date: Mon, 5 Feb 2018 05:49:43
 From: john doe <johndoe65534@mail.com>
 To: debian-accessibility@lists.debian.org
 Subject: Re: debian-buster-di-alpha2-x86_64 standard system install
 Resent-Date: Mon,? 5 Feb 2018 10:50:02 +0000 (UTC)
 Resent-From: debian-accessibility@lists.debian.org

 On 2/5/2018 9:51 AM, Jude DaShiell wrote:

 ?I checked the dvd integrity and integrity check was successful.? I
 ?installed on a 3tb disk using espeak and had grub for boot loader.
 ?Finishing the install ejected the dvd at 61% and I hit enter then the 

 If the installer stopped at 61%; clearly some components are missing.
 What happened at 61% or what am I missing?


 ?system got lost in space so I powered down waited about a minute and
 tried
 ?booting the system.? No beep from grub and no speech either.? Could it 
 be
 ?the espeak stuff didn't also have its configuration stuff saved to the 
 new
 ?installation but the orca stuff got saved?



 - Do you know if the system can boot (can you ping it)?
 - Did you install ssh; if yes can you remotely access that host?
 - Maybe using Debian rescue?
 - Can you mount that partition from an other system?













--
John Doe
Reply to: