Re: PCC error
On Thu, Sep 06, 2001 at 04:44:27PM -0700, Rick Eicher II wrote:
> When I enter pcc I get failed
> --SCSI port reset signal is active---
>
> Any one know how to fix this on a mvme147 board?
Hmm, do you have any terminators on your scsi bus? Lack of termination
might just cause that. Typically you might find terminators on a small
pcb plugged on to the back of the backplane (P2). There is a fuse to
power the terminators on that pcb as well, iirc.
Richard
Reply to:
- References:
- PCC error
- From: "Rick Eicher II" <rick@texol.net>