Re: Booting a 2.2 kernel on an SE/30
> There are several screens full of messages which I don't want to type
> in; here are a few that seem more important than the others:
>
> mac_insert_irq: Warning: dev_id of MacSCSI5380 is zero
May be normal; I think the 5380 driver doesn't use the dev_id field as the
int isn't shared with other drivers.
> scsi0: generic 5380 at port 50F10000 irq 19 options CAN_QUEUE=4
> CMD_PER_LUN=2 release=1
> scsi0: generic options AUTOSENSE generic release=7
> scsi0 :
> scsi : 1 host.
> scsi : aborting command due to timeout : pid 0, scsi0, channel 0, id
> 0, lun 0 Test Unit Ready 00 00 00 00 00
> NCR5380 : Coroutine isn't running.
> STATUS_REG: 00
> BASR: 18
> ICR: 00
> MODE: 00
> scsi0 REQ not asserted, phase unknown.
>
>
> Has anybody else been down this road successfully? I don't understand
> the significance of the mac5380=2,4 kernel options so I don't know
> whether I should try other values.
Rather looks like generic SCSI interrupt breakage to me. Check that the
Mac interrupt code sets the edge direction for the SCSI interrupt properly
like in the 2.0.36 version.
Michael
Reply to: