Re: solaris cdrecord BH08LS20 drive BD-R problems
Jörg, thank you for answering the formatting question.
Note that my blu-ray drive is connected to my system via USB 2.0
I do not understand why DMA settings may be a problem for cdrecord.
With cdrecord I can write to DVD (Plextor PX-716UF) over USB 2.0
Memorex (actually RITEK) is definitely not the highest quality media.
However, cdrecord -minfo gives the same result with Verbatim discs.
Here are the errors I see with the cdrecord -atip command:
# cdrecord dev=3,0,0 -atip
Cdrecord-ProDVD-ProBD-Clone 2.01.01a61 (sparc-sun-solaris2.10)
scsidev: '3,0,0'
scsibus: 3 target: 0 lun: 0
Warning: Using USCSI interface.
Using libscg version 'schily-0.9'.
Device type : Removable CD-ROM
Version : 0
Response Format: 2
Capabilities :
Vendor_info : 'HL-DT-ST'
Identifikation : 'BD-RE BH08LS20 '
Revision : '1.00'
Device seems to be: Generic mmc2 DVD-R/DVD-RW/DVD-RAM.
Using generic SCSI-3/mmc-3 BD-R driver (mmc_bdr).
Driver flags : NO-CD BD MMC-3 BURNFREE
Supported modes: PACKET SAO LAYER_JUMP
Disk type: 'BDR' (BD-R)
Disk class: 01
Manufacturer: 'RITEK'
Media type: 'BR2'
Disk: is not in cartridge
Media cartrige: write protect is off
{{{ ... gets_hung_for_long_time ... }}}
cdrecord: I/O error. read disk info: scsi sendcmd: no error
CDB: 51 00 00 00 00 00 00 00 04 00
status: 0x0 (GOOD STATUS)
resid: 4
cmd finished after 0.029s timeout 240s
cdrecord: Cannot get disk type.
cdrecord: I/O error. prevent/allow medium removal: scsi sendcmd: no error
CDB: 1E 00 00 00 00 00
status: 0x0 (GOOD STATUS)
cmd finished after 0.039s timeout 100s
The next time I try to use cdrecord, it tells me to power cycle the drive.
This LG drive (and Memorex media) works using Power2Go on Windows,
but I need to use the drive to archive data on my solaris sparc machines.
Please help me to get cdrecord able to read the media correctly,
and then perhaps get it to write my ISO images to blu-ray discs.
Thank you.
Reply to: