Re: SCSI-Problem mit Symbios Logic 53c875
Am Sonntag, 18. September 2005 00:43 schrieb Andreas Kroschel:
Ich komme jetzt nochmals auf den hwinfo-Eintrag zurück
Driver Info #0:
Driver Status: ncr53c8xx is not active
Driver Activation Cmd: "modprobe ncr53c8xx"
Driver Info #1:
Driver Status: sym53c8xx is active
Driver Activation Cmd: "modprobe sym53c8xx"
Config Status: cfg=new, avail=yes, need=no, active=unknown
Auf http://www.dawicontrol.de/german/html/linux.htm liest man:
DC-2975 U Symbios 53C875 NCR53C8xx *oder* Symbios875
lspci -vvv
0000:00:08.0 SCSI storage controller: LSI Logic / Symbios Logic 53c875 (rev
26)
Subsystem: LSI Logic / Symbios Logic LSI53C876/E PCI to Dual Channel
SCSI Controller
Control: I/O+ Mem+ BusMaster- SpecCycle- MemWINV+ VGASnoop- ParErr-
Stepping- SERR- FastB2B-
Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
Interrupt: pin A routed to IRQ 177
Region 0: I/O ports at d000 [size=256]
Region 1: Memory at ea013000 (32-bit, non-prefetchable) [size=256]
Region 2: Memory at ea010000 (32-bit, non-prefetchable) [size=4K]
Capabilities: [40] Power Management version 1
Flags: PMEClk- DSI- D1- D2- AuxCurrent=0mA
PME(D0-,D1-,D2-,D3hot-,D3cold-)
Status: D0 PME-Enable- DSel=0 DScale=0 PME-
Kann ich nun aufgrund lspci schließen, das mein Controller einen Symbios-Chip
hat?
Ich habe es mal testweise probiert:
modprobe ncr53c8xx
FATAL: Module ncr53c8xx not found
Al
Reply to: