Re: LSB setup.sh errors
On Tue, 11 Sep 2001, Christopher Yeoh wrote:
> Suzanne Hillman writes:
> > On Wed, 5 Sep 2001, Christopher Yeoh wrote:
> >
> > > Suzanne Hillman writes:
> > > >
> > > > The install file is below. An error which I had not previously seen
> > > > relates to an inability to find 'mqueue.h', which is apparently something
> > > > supposed to be found in one of the include directories I listed during the
> > > > config phase, since it is not located within the files installed by the
> > > > install.sh.
> > >
> > > Could you check /usr/include/bits/posix_opt.h and see if
> > > _POSIX_MESSAGE_PASSING is defined? Some older versions of glibc
> > > erroneously define this to be -1 instead of #undef'ing it.
> >
> > It's not in there at all.
>
> Another person reported this compilation problem and I just had
> another look into it. If you install both the vsx-pcts and lsb-os test
> suites and choose the POSIX96 test mode (which is the default mode)
> then the compilation problems occur. Another bad side effect is that
> even if the compilation problems are fixed only the vsx-pcts tests are
> setup to run. Using the UNIX98 test mode instead works.
>
> I'll change the default so it uses the UNIX98 test mode.
>
> Andrew - I think we'll have to change the FHS test suite so it can run
> in the UNIX98 test mode so all the test suites can be installed and
> run at the same time.
>
I have not seen these issues, and I have base, fhs, usersgroups and lite
all installed. I don't even see UNIX98 offered as a test mode? Am I doing
something drastically wrong?
Thx,
Stew Benedict
Reply to: