Bug#226973: xserver-xfree86: [glint] second card at wrong resolution
On Wed, Jan 14, 2004 at 04:06:35PM -0500, Clint Adams wrote:
> > Yep. It probably doesn't happen on x86, since the int10 stuff
> > initializes the card with the onboard bios. Using a x86 emulator in X to
> > run this bios might be a solution.
>
> According to Tech-Source, this card has no VGA bios..
Ok. An OF driver then ?
> > Ho. definitively some registers who are bad. It has been a long time
> > since i have looked at the pm2 specs (kind of 98ish i think) though.
> > Maybe you could get hand of the free TI-pm2 specs and look for yourself ?
>
> I've been looking and not finding anything.
you did not find the specs, or you didn't find anything ?
> > You would dump all the possible registers, and see which one is
> > different. Enabling debugging in the glint driver would also do. You can
> > safely run no-accel on these for the tests, as this is definitively not
> > an accel issue, but a video out/ramdac one.
>
> Attached is the XFree86.0.log from xserver-xfree86-dbg. I'll start it
> again with noaccel. The only thing I notice is that it thinks the
> second card only has 4 megs of video ram.
Nope, this is not the right way, you have to rebuild the driver and add
some code to drop the content of the registers somewhere.
I don't have time right now, maybe later i will find time to send you a
register dropping patch or something.
Friendly,
Sven Luther
Reply to: