Re: encrypt/lvm issue during install.... [WAS: location of screenshots during debian install
On Wed, 2021-07-28 at 13:31 +0100, Tixy wrote:
> On Wed, 2021-07-28 at 07:54 -0400, Greg Wooledge wrote:
> > On Tue, Jul 27, 2021 at 10:05:54PM -0600, Jupiter777 wrote:
> > > so loop-with-no-exit went like:
> > >
> > >
> > > -- installer recognized the disk, OK
> > >
> > > -- did the 1gb /boot ext2 non-encrypted configured , OK /dev/sda7
> > >
> > > -- 150gb partition, planned to be / with everything in it,
> > > recognized by installer, OK /dev/sda6
> > >
> > > -- configured /dev/sda6 to be / and mount-point / too , OK
> > >
> > > -- went inside the lvm config/manager ....
> > >
> > > -- added volume group vg1 off of /dev/sda6 , OK
> > >
> > > -- added logical volume lv1 (inside vg1) , OK
> >
> > I've never done disk encryption, so I can only speak to the LVM parts
> > of this.
> >
> > If you're planning to use LVM for everything except /boot, then your
> > third and fourth steps above are incorrect. You don't want to create
> > a regular root file system on sda6 if you're planning to use sda6 for LVM.
> >
> > What you want to do instead is:
> >
> > 1) Create your /boot partition + file system as you did.
> >
> > 2) Create a partition to hold the LVM subsystem, but do not mount it.
> >
> > 3) Go into the LVM subsystem, and turn your empty partition into a
> > volume group.
> >
> > 4) Create logical volumes within the VG for each file system you want,
> > including root.
> >
> > However, since you were trying to do encryption as well, you should
> > definitely look for advice from someone who has done that.
>
> Between steps 2) and 3) you encrypt the partition.
Well, that's what I do, but if you want to encrypt filesystems
individually then I don't know what the sequence is for that.
--
Tixy
Reply to: