Re: Networking nonfunctional on 8.0
On Wed, 27 Jul 2016 20:46:23 +0200, you wrote:
>Le 27/07/2016 à 15:43, Steve Matzura a écrit :
>> My 8.0 system has been running great up until Monday evening when
>> users started reporting they were unable to connect. Sure enough, I
>> couldn't even connect from my LAN. I rebooted, looked at messages from
>> dmesg, and saw nothing unusual--nothing that said networking couldn't
>> start, or there was a hardware failure, nothing to indicate a problem.
>> What should I check next?
>
>Check the current network (link+IP) configuration.
>
>ifconfig -a
eth0 Link encap:Ethernet HWaddr bc:5f:f4:5b:80:09
inet addr:192.168.1.130 Bcast:192.168.1.255
Mask:255.255.255.0
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:65536 Metric:1
RX packets:45 errors:0 dropped:0 overruns:0 frame:0
TX packets:45 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:3794 (3.7 KiB) TX bytes:3794 (3.7 KiB)
>ip addr
1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN
group default
link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
inet 127.0.0.1/8 scope host lo
valid_lft forever preferred_lft forever
inet6 ::1/128 scope host
valid_lft forever preferred_lft forever
2: eth0: <NO-CARRIER,BROADCAST,MULTICAST,UP> mtu 1500 qdisc pfifo_fast
state DOWN group default qlen 1000
link/ether bc:5f:f4:5b:80:09 brd ff:ff:ff:ff:ff:ff
inet 192.168.1.130/24 brd 192.168.1.255 scope global eth0
valid_lft forever preferred_lft forever
>ip route
default via 192.168.1.1 dev eth0
192.168.1.0/24 dev eth0 proto kernel scope link src 192.168.1.130
Provided by sneakernet. I mounted a thumb drive and redirected the
output from the above commands thereto, then pasted the files herein.
Reply to: