Re: Bond and Bridge problem
On 21.03.2016 09:31, Igor Cicimov wrote:
> The problem is when I do `service networking restart` I get this message:
> RTNETLINK answers: invalid argument
> Failed to bring up br0
So, to overcome MTU problem, this is my interfaces:
auto eth0
iface eth0 inet manual
bond-master bond0
up ip link set eth0 mtu 9000
auto eth1
iface eth1 inet manual
bond-master bond0
up ip link set eth1 mtu 9000
auto bond0
iface bond0 inet manual
# load balancing and fault tolerance
bond-mode 802.3ad
bond-miimon 100
bond-downdelay 200
bond-updelay 200
bond-lacp-rate 4
up ip link set bond0 mtu 9000
auto br0
iface br0 inet static
address 10.10.0.159
netmask 255.255.0.0
gateway 10.10.0.254
# vlan-raw-device bond0
bridge_ports bond0
bridge_stp off
# bridge_fd 0
# bridge_maxage 0
bridge_ageing 0
bridge_maxwait 0
up ip link set br0 mtu 9000
Reply to: