Re: Why does Debian not recognize my USB3 disk drive?

[Rick Thomas <rbthomas@pobox.com>]

On 08/30/15 21:34, Rick Thomas wrote:
> I’ll plug in a disk and test it next chance I get, if you think it will help.
Plugging the disk in after reboot shows nothing happening with the USB3 
card.

Plugging it into the USB2 card gets the expected
> [  372.956020] usb 8-3: new high-speed USB device number 2 using ehci-pci
> [  373.097430] usb 8-3: New USB device found, idVendor=05dc, 
> idProduct=a838
> [  373.097434] usb 8-3: New USB device strings: Mfr=1, Product=2, 
> SerialNumber=3
> [  373.097437] usb 8-3: Product: USB Flash Drive
> [  373.097439] usb 8-3: Manufacturer: Lexar
> [  373.097442] usb 8-3: SerialNumber: AALBOCEKDL6LQK8A
> [  373.129075] usb-storage 8-3:1.0: USB Mass Storage device detected
> [  373.129229] scsi host5: usb-storage 8-3:1.0
> [  373.129364] usbcore: registered new interface driver usb-storage
> [  373.143513] usbcore: registered new interface driver uas
> [  374.434275] scsi 5:0:0:0: Direct-Access     Lexar    USB Flash 
> Drive  1100 PQ: 0 ANSI: 6
> [  374.434685] sd 5:0:0:0: Attached scsi generic sg4 type 0
> [  374.436135] sd 5:0:0:0: [sdc] 62517248 512-byte logical blocks: 
> (32.0 GB/29.8 GiB)
> [  374.436998] sd 5:0:0:0: [sdc] Write Protect is off
> [  374.437002] sd 5:0:0:0: [sdc] Mode Sense: 43 00 00 00
> [  374.437878] sd 5:0:0:0: [sdc] Write cache: enabled, read cache: 
> enabled, doesn't support DPO or FUA
> [  374.453902]  sdc: sdc1 sdc2
> [  374.458001] sd 5:0:0:0: [sdc] Attached SCSI removable disk