Re: How to configure eth0 with static ip and eth1 dhcp
On 23/02/14 09:22, Markos wrote:
> Hi all,
>
>
> I'm trying to configure a machine with two network cards to share
> Internet access to an internal network
>
> the /etc/network/interface is:
>
> # The loopback network interface
> auto lo
> iface lo inet loopback
>
> auto eth0
> iface eth0 inet static
> address 192.168.0.1
> netmask 255.255.255.0
gateway 192.168.1.1
>
<snipped>
allow-hotplug eth1
> iface eth1 inet dhcp
>
> The card eth0 is used as gateway on the internal network with static IP
> 192.168.0.1 and eth1 is connected to the B-890 -53 Huawei modem.
>
> But the modem do not send an IP during initialization.
>
> The IP of modem is192.168.1.1.
>
> The modem sends the IP address (192.168.0.4) to my laptop by wifi
> without problems.
I'm not sure what you mean there...
>
> Any suggestions of what I should check?
route(?)
You should probably see something like:-
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use
Iface
default modem 0.0.0.0 UG 0 0 0 eth1
localnet * 255.255.255.0 U 0 0 0 eth0
192.168.1.0 * 255.255.255.0 U 0 0 0 eth1
>
> Thanks,
> Markos
>
Kind regards
Reply to: