Ok, Here are what I have done though I really have lost track of things I've done as I just follow what I could find...
I did this.
and I did this.
This returns 0. Now, I did following as you suggested, ping -c 5 google.com PING google.com (173.194.38.64) 56(84) bytes of data. 64 bytes from nrt19s17-in-f0.1e100.net (173.194.38.64): icmp_req=1 ttl=54 time=17.2 ms 64 bytes from nrt19s17-in-f0.1e100.net (173.194.38.64): icmp_req=2 ttl=54 time=17.1 ms 64 bytes from nrt19s17-in-f0.1e100.net (173.194.38.64): icmp_req=3 ttl=54 time=16.9 ms 64 bytes from nrt19s17-in-f0.1e100.net (173.194.38.64): icmp_req=4 ttl=54 time=21.1 ms 64 bytes from nrt19s17-in-f0.1e100.net (173.194.38.64): icmp_req=5 ttl=54 time=17.2 ms --- google.com ping statistics --- 5 packets transmitted, 5 received, 0% packet loss, time 4003ms rtt min/avg/max/mdev = 16.955/17.942/21.102/1.583 ms then, ping -c 5 101.119.11.99 PING 101.119.11.99 (101.119.11.99) 56(84) bytes of data. 64 bytes from 101.119.11.99: icmp_req=1 ttl=48 time=138 ms 64 bytes from 101.119.11.99: icmp_req=2 ttl=48 time=130 ms 64 bytes from 101.119.11.99: icmp_req=3 ttl=48 time=132 ms 64 bytes from 101.119.11.99: icmp_req=4 ttl=48 time=133 ms 64 bytes from 101.119.11.99: icmp_req=5 ttl=48 time=135 ms --- 101.119.11.99 ping statistics --- 5 packets transmitted, 5 received, 0% packet loss, time 4005ms rtt min/avg/max/mdev = 130.803/134.260/138.205/2.539 ms also, cat /etc/resolv.conf # Generated by NetworkManager nameserver 192.168.1.254 ## 192.168.1.254 is the IP for the router. route Kernel IP routing table Destination Gateway Genmask Flags Metric Ref Use Iface default 192.168.1.254 0.0.0.0 UG 0 0 0 eth0 localnet * 255.255.255.0 U 0 0 0 eth0 ifconfig $dev eth0 Link encap:Ethernet HWaddr 00:1c:c0:19:ba:33 inet addr:192.168.1.15 Bcast:192.168.1.255 Mask:255.255.255.0 UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 RX packets:325430 errors:0 dropped:23 overruns:0 frame:0 TX packets:239942 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:1000 RX bytes:273528223 (260.8 MiB) TX bytes:41728298 (39.7 MiB) Interrupt:20 Memory:e0300000-e0320000 lo Link encap:Local Loopback inet addr:127.0.0.1 Mask:255.0.0.0 UP LOOPBACK RUNNING MTU:16436 Metric:1 RX packets:8 errors:0 dropped:0 overruns:0 frame:0 TX packets:8 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:0 RX bytes:400 (400.0 B) TX bytes:400 (400.0 B) ip a 1: lo: <LOOPBACK,UP,LOWER_UP> mtu 16436 qdisc noqueue state UNKNOWN link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00 inet 127.0.0.1/8 scope host lo 2: eth0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc pfifo_fast state UP qlen 1000 link/ether 00:1c:c0:19:ba:33 brd ff:ff:ff:ff:ff:ff inet 192.168.1.15/24 brd 192.168.1.255 scope global eth0 I could get up to here... From "curl" thing, I get very long response tagged with <html>.... I am lost.... A.K. On 12/28/2013 11:16 PM, Scott Ferguson
wrote:
On 29/12/13 00:26, Man_Without_Clue wrote:Hi all, I have asked this question everywhere, but still haven't gotten clear and solid solutions yet, so I thought I would send this to this list.Perhaps because there are an unknown number of causes for the "problem" and because you've provided no information about your network. :)As title says, internet loads too slow on Debian Wheezy amd 64. I have searched web and have done several methods to turn ipv6 off including Iceweasel, but still websites load slow. Any additional advise ?See below. *Important* please tell us what you have done to "disable IPV6" *and* your home network configuration, ISP plan, etc (do you really not have IPV6?).Thanks in advance. A.K.What part of the internet loads slow? e.g. DNS results, browser page, slow internet etc. Check the DNS by pinging a domain name then it's IP address and posting your results e.g.:- $ ping -c 5 google.com PING google.com (101.119.11.99) 56(84) bytes of data. 64 bytes from google.com (101.119.11.99): icmp_req=1 ttl=60 time=77.5 ms 64 bytes from google.com (101.119.11.99): icmp_req=2 ttl=60 time=67.5 ms 64 bytes from google.com (101.119.11.99): icmp_req=3 ttl=60 time=68.0 ms 64 bytes from google.com (101.119.11.99): icmp_req=4 ttl=60 time=86.6 ms 64 bytes from google.com (101.119.11.99): icmp_req=5 ttl=60 time=63.2 ms --- google.com ping statistics --- 5 packets transmitted, 5 received, 0% packet loss, time 4004ms rtt min/avg/max/mdev = 63.284/72.615/86.673/8.442 ms scott@vbserver:~/Downloads/kernel$ ping -c 5 101.119.11.99 PING 101.119.11.99 (101.119.11.99) 56(84) bytes of data. 64 bytes from 101.119.11.99: icmp_req=1 ttl=60 time=66.6 ms 64 bytes from 101.119.11.99: icmp_req=2 ttl=60 time=65.1 ms 64 bytes from 101.119.11.99: icmp_req=3 ttl=60 time=65.8 ms 64 bytes from 101.119.11.99: icmp_req=4 ttl=60 time=83.2 ms 64 bytes from 101.119.11.99: icmp_req=5 ttl=60 time=75.1 ms --- 101.119.11.99 ping statistics --- 5 packets transmitted, 5 received, 0% packet loss, time 4005ms rtt min/avg/max/mdev = 65.100/71.195/83.222/7.028 ms NOTE: my system uses a wireless broadband connection so slow responses are normal for this network. Show us your nameserver settings by posting the output of:- $ cat /etc/resolv.conf Show us the routing by posting the output of:- # route See if you are dropping packets by substituting $dev with your internet connection device:- # ifconfig $dev e.g eth1 is my internet connection and it's dropped no packets # ifconfig eth0 eth0 Link encap:Ethernet HWaddr 00:20:ed:8f:ab:fd inet addr:192.168.0.6 Bcast:192.168.0.255 Mask:255.255.255.0 UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 RX packets:89090 errors:0 dropped:0 overruns:0 frame:0 TX packets:188186 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:1000 RX bytes:14993111 (14.2 MiB) TX bytes:248603032 (237.0 MiB) Interrupt:22 Base address:0xe000 Show us your NICs by posting the output of:- $ ip a Test your download speed with curl ("# apt-get install curl" if you don't have it). This will is to distiguish between network speed and browser speed e.g.:- $ curl http://www.debian.org -w %{time_connect}:%{time_starttransfer}:%{time_total}:%{size_download} NOTE: I get 0.930:1.787:2.016:13655 Lastly check dmesg and /var/log/syslog for pertinent errors, check top and free for system resource restraints. Kind regards |