On Thu, Dec 13, 2012 at 3:31 PM, Andrei POPESCU
<andreimpopescu@gmail.com> wrote:
On Jo, 13 dec 12, 14:29:21, magina antimage wrote:
>
> A)cable connected
>
> #nmcli dev
>
> DEVICE TYPE STATE
> eth0 802-3-ethernet connected
>
> B)cable not connected
>
> #nmcli dev
>
> DEVICE TYPE STATE
> eth0 802-3-ethernet connected
>
>
> it gives same o/p :(
Ok, let's try a bit deeper. Could you please post the output of
ip link show eth0
with and without the cable.
ip link show eth0
A) With cable
2: eth0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc pfifo_fast state UP qlen 1000
link/ether 00:13:20:fc:65:04 brd ff:ff:ff:ff:ff:ff
B) without cable
2: eth0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc pfifo_fast state UP qlen 1000
link/ether 00:13:20:fc:65:04 brd ff:ff:ff:ff:ff:ff
also i noticed one thing,when i plug out my Ethernet cable it shows following msg on console
e1000: eth0 NIC Link is Down
e1000: eth0 NIC Link is Up 100 Mbps Full Duplex, Flow Control: RX/TX
i didn't plugged in my cable but still in above log it shows link is up .