Re: [OT] revolver postgresql issue
On Tue, 15 May 2012 14:02:50 +0200
Johann Spies <jspies@sun.ac.za> wrote:
> On Tue, May 15, 2012 at 01:26:57PM +0200, J. Bakshi wrote:
> >
> > I am using revolver solo version 8.4.6
> > The system is working fine. I need to communicate the postgresql
> > remotely, but the port 9977 which postgresql uses for revolver is bind
> > to the localhost only.
> >
> > At postgresql.conf there is already
> >
> > listen_addresses = '*'
>
> This means: listen an all interfaces - not on localhost only.
>
> > and at pg_hba.conf I have added the following
> >
> > host all all 0.0.0.0/0 trust
> > host all all 192.168.0.1/24 password
> > host all revolverserver 192.168.1.154 trust
> >
> > The winxp box has firewall disabled. Still the port 9977 is not visible from any
> > other PC of the same LAN. How can I open the port then for all ?
>
> Where is the configuration to make Postgresql listen on port 9977? That
> is not a normal postgresql setup. Normally it will listen on port 5432.
>
Yes, revolver software use port 9977 for postgresql. This can be changed easily,
but the problem is it is binded to localhost only even after
listen_addresses = '*'
Reply to: