Re: Installing a Broadcom 4312 rev 02 wifi card
El vie, 27-02-2009 a las 16:22 -0500, Celejar escribió:
> On Fri, 27 Feb 2009 15:39:55 +0100
> Korrignu <korrignu@gmail.com> wrote:
>
> ...
>
>
> > 06:00.0 Network controller: Broadcom Corporation BCM4312 802.11b/g (rev 01)
>
> ...
>
> > [ 630.553689] Broadcom 43xx driver loaded [ Features: PMLR,
> > Firmware-ID: FW13 ]
> >
> > it seems weird that there is only one line about the b43 module...
>
> The driver is definitely not picking up the card. Here's what it should look like:
>
> [ 2620.611136] b43-phy2: Broadcom 4318 WLAN found (core revision 9)
> [ 2620.626037] b43-phy2 debug: Found PHY: Analog 3, Type 2, Revision 7
> [ 2620.626062] b43-phy2 debug: Found Radio: Manuf 0x17F, Version 0x2050, Revision 8
> [ 2620.636899] phy2: Selected rate control algorithm 'minstrel'
> [ 2620.637796] Broadcom 43xx driver loaded [ Features: PLR, Firmware-ID: FW13 ]
It is well documented that b43 + bcm43xx at the same box create
conflicts. It looks as if you have both installed, do you?
>
> You should probably take this to the b43 mailing list. [Warning:
> politeness and RTFM are important there.]
>
> Celejar
Reply to: