[Date Prev][Date Next] [Thread Prev][Thread Next] [Date Index] [Thread Index]

Cdrecord loses permission to write CD's...



After copying one CD, I find cdrecord losing it's permission to write to
the blank for a second, new CD.  Any thoughts why this is happening?
Info is in the debugging output below.  I was running Fluxbox after a
reboot.

FWIW I have difficulties as well getting the Plextor drive to be
recognized under Gnome, with it winding up spitting out "not ready"
messages on every terminal screen following attempts to use K3B or any
other CD software.  I've had to reboot to reset things.  Is this a hald
issue perhaps?

TIA for any help!


Kenward

-------------------
Below is the debugging output from K3B:

System
-----------------------
K3b Version: 1.0.5

KDE Version: 3.5.9
QT Version:  3.3.8b
Kernel:      2.6.26
Devices
-----------------------
LITE-ON DVD D LH-16D1P TL13 (/dev/hdb, ) [CD-ROM, DVD-ROM] [DVD-ROM,
CD-ROM] [None]

PLEXTOR DVDR   PX-708A 1.03 (/dev/hda, ) [CD-R, CD-RW, CD-ROM, DVD-ROM,
DVD-R, DVD-RW, DVD+R, DVD+RW] [DVD-ROM, DVD-R Sequential, DVD-RW
Restricted Overwrite, DVD-RW Sequential, DVD+RW, DVD+R, CD-ROM, CD-R,
CD-RW] [SAO, TAO, RAW, SAO/R96P, SAO/R96R, RAW/R16, RAW/R96P, RAW/R96R,
Restricted Overwrite]
Used versions
-----------------------
cdrecord: 1.1.8

cdrecord
-----------------------
/usr/bin/wodim: Operation not permitted. Warning: Cannot raise
RLIMIT_MEMLOCK limits.scsidev: '/dev/hda'
devname: '/dev/hda'
scsibus: -2 target: -2 lun: -2
Linux sg driver version: 3.5.27
Wodim version: 1.1.8
SCSI buffer size: 64512
Beginning DMA speed test. Set CDR_NODMATEST environment variable if
device
communication breaks or freezes immediately after that.
TOC Type: 0 = CD-DA
Driveropts: 'burnfree'
Device type    : Removable CD-ROM
Version        : 0
Response Format: 1
Vendor_info    : 'PLEXTOR '
Identification : 'DVDR   PX-708A  '
Revision       : '1.03'
Device seems to be: Generic mmc2 DVD-R/DVD-RW.
Current: 0x0009 (CD-R)
Profile: 0x001B (DVD+R) 
Profile: 0x001A (DVD+RW) 
Profile: 0x0014 (DVD-RW sequential recording) 
Profile: 0x0013 (DVD-RW restricted overwrite) 
Profile: 0x0011 (DVD-R sequential recording) 
Profile: 0x0010 (DVD-ROM) 
Profile: 0x000A (CD-RW) 
Profile: 0x0009 (CD-R) (current)
Profile: 0x0008 (CD-ROM) 
Using generic SCSI-3/mmc   CD-R/CD-RW driver (mmc_cdr).
Driver flags   : MMC-3 SWABAUDIO BURNFREE 
Supported modes: TAO PACKET SAO SAO/R96P SAO/R96R RAW/R16 RAW/R96P
RAW/R96R
Drive buf size : 1190112 = 1162 KB
Drive DMA Speed: 1341 kB/s 7x CD 0x DVD
FIFO size      : 12582912 = 12288 KB
Encoding speed : 909x (68123 sectors/s) for libedc from Heiko Eißfeldt
Track1 Start: '32' (32)
pregap1: 182
Track 01: audio   38 MB (03:49.70) no preemp      pregapsize: 182
Track 02: audio   10 MB (01:02.86) no preemp      pregapsize:   0
...

Track 25: audio   18 MB (01:52.77) no preemp      pregapsize:   0
Total size:      548 MB (54:17.80) = 244335 sectors
Lout start:      548 MB (54:19/60) = 244335 sectors
Current Secsize: 2048
ATIP info from disk:
  Indicated writing power: 5
  Is not unrestricted
  Is not erasable
  Disk sub type: Medium Type A, high Beta category (A+) (3)
  ATIP start of lead in:  -11634 (97:26/66)
Speed set to 7056 KB/s
/usr/bin/wodim: DMA speed too slow (OK for 6x). Cannot write at speed
40x.
  ATIP start of lead out: 359846 (79:59/71)
Disk type:    Short strategy type (Phthalocyanine or similar)
Manuf. index: 3
Manufacturer: CMC Magnetics Corporation
Blocks total: 359846 Blocks current: 359846 Blocks remaining: 115511
Starting to write CD/DVD at speed  40.0 in real RAW/RAW96R mode for
single session.
Last chance to quit, starting real write in    2 seconds.
   1 seconds.
   0 seconds.
 Operation starts.
Waiting for reader process to fill input buffer ... input buffer ready.
Performing OPC...
Errno: 0 (Success), write_g1 scsi sendcmd: no error
CDB:  2A 00 FF FF D4 7C 00 00 1A 00
status: 0x2 (CHECK CONDITION)
Sense Bytes: F0 00 03 FF FF D5 12 0A 00 00 00 00 0C 07 00 00
Sense Key: 0x3 Medium Error, Segment 0
Sense Code: 0x0C Qual 0x07 (write error - recovery needed) Fru 0x0
Sense flags: Blk -10990 (valid) 
resid: 63648
cmd finished after 1.861s timeout 40s
/usr/bin/wodim: Could not write Lead-in.
Writing lead-in at sector -11634
write leadin data: error after 1209312 bytes
Writing  time:   30.620s
/usr/bin/wodim: fifo had 191 puts and 0 gets.
/usr/bin/wodim: fifo was 0 times empty and 0 times full, min fill was
100%.

cdrecord command:
-----------------------
/usr/bin/wodim -v gracetime=2 dev=/dev/hda speed=40 -raw96r
driveropts=burnfree -eject -text -useinfo -audio
-shorttrack /opt/film/k3bCdCopy0/Track01.wav /opt/film/k3bCdCopy0/Track02.wav /opt/film/k3bCdCopy0/Track03.wav /opt/film/k3bCdCopy0/Track04.wav /opt/film/k3bCdCopy0/Track05.wav /opt/film/k3bCdCopy0/Track06.wav /opt/film/k3bCdCopy0/Track07.wav /opt/film/k3bCdCopy0/Track08.wav /opt/film/k3bCdCopy0/Track09.wav /opt/film/k3bCdCopy0/Track10.wav /opt/film/k3bCdCopy0/Track11.wav /opt/film/k3bCdCopy0/Track12.wav /opt/film/k3bCdCopy0/Track13.wav /opt/film/k3bCdCopy0/Track14.wav /opt/film/k3bCdCopy0/Track15.wav /opt/film/k3bCdCopy0/Track16.wav /opt/film/k3bCdCopy0/Track17.wav /opt/film/k3bCdCopy0/Track18.wav /opt/film/k3bCdCopy0/Track19.wav /opt/film/k3bCdCopy0/Track20.wav /opt/film/k3bCdCopy0/Track21.wav /opt/film/k3bCdCopy0/Track22.wav /opt/film/k3bCdCopy0/Track23.wav /opt/film/k3bCdCopy0/Track24.wav /opt/film/k3bCdCopy0/Track25.wav 



-- 
The church says the earth is flat, but I know that it is round, for I
have seen the shadow on the moon, and I have more faith in a shadow than
in the church.    --Ferdinand Magellan



Reply to: