Re: Kernel panic installing Etch
2008/3/3, Douglas A. Tutty <dtutty@porchlight.ca>:
> On Mon, Mar 03, 2008 at 07:50:15PM -0300, Juan Seet wrote:
> > Hello, I downloaded netinst for AMD64, I tried to install it and I get
> > the following message:
> > Code: 89 d5 81 e5 ff 00 00 00 75 70 48 c1 ea 08 48 8d b3 18 10 00
> > console shuts up ...
> > <0>Kernel panic - not syncing: Aiee, killing interrupt handler!
> >
> > System data:
> > Processor: DualCore AMD Athlon 64 X2, 2100 MHz (10.5 x 200) 4000+
> > Motherboard: ECS AMD690GM-M2
> > Chipset: AMD 690G, AMD Hammer
> > Memory: 2048 MB (DDR2-667 DDR2 SDRAM)
> > Video card: ATI Radeon X1650 Series (512 MB)
> >
> > Any idea? Thanks for your time.
>
>
> You don't say if this is Sarge, Etch, Lenny, or Sid. Its important.
>
> Equally important, you should read the installation manual where it says
> what to do if you have a problem: the same as if you don't: send in an
> installation report. Since you have a problem, subscribe to debian-boot
> first where your email well get posted by the installation reports
> system. The people who lurk on that list are the people who write the
> installer and ensure that it boots. They will either know right away
> what to do, or will tell you what magical incantation to give the kernel
> so that it says something that will help them help you.
>
> Good luck.
>
> Doug.
0k thanks, I'll suscribe to debian-boot, but this mail subject is
"Kernel panic installing Etch" ;)
Reply to: