Intel pro100 NIC problem in Etch
Dear all,
I have a Intel pro100 network card in my PC. The system loads kernel module `e100' automatically when booting. But ifconfig eth0 up failed. If I manually load `eepro100', ifconfig also failed. This is some output:
# modprobe eepro100
PCI: Enabling device 0000:02:02.0 (0110 -> 0113)
ACPI: PCI Interrupt 0000:02:02.0[A] -> GSI 18 (level, low) -> IRQ 185
eth0: 0000:02:02.0, 00:0E:0C:5E:4B:06, IRQ 185.
Board assembly 741462-017, Physical connectors present: RJ45
Primary interface chip i82555 PHY #1.
General self-test: passed.
Serial sub-system self-test: passed.
Internal registers self-test: passed.
ROM checksum self-test: passed (0x04f4518b).
# ifconfig eth0 up
eth0: ERRor while getting interface flags: No such device
# cat /proc/interrupts
CPU0
0: 692389 IO-APIC-edge timer
1: 1242 IO-APIC-edge i8042
6: 5 IO-APIC-edge floppy
7: 0 IO-APIC-edge parport0
8: 1 IO-APIC-edge rtc
9: 1 IO-APIC-level acpi
14: 4184 IO-APIC-edge ide0
15: 24753 IO-APIC-edge ide1
169: 272 IO-APIC-level uhci_hcd:usb1,
radeon@pci:0000:01:00.0
177: 0 IO-APIC-level uhci_hcd:usb2
185: 0 IO-APIC-level uhci_hcd:usb3
193: 0 IO-APIC-level ehci_hcd:usb4
201: 0 IO-APIC-level Intel 82801DB-ICH4
NMI: 0
LOC: 692339
ERR: 0
MIS: 0
It seems there's IRQ conflict (IRQ 185). However, I use a SLAX live CD to boot the same machine, the NIC works well.
My environment:
Debian Etch: kernel 2.6.18-4-686
a Dell Pentium 4 PC
Any direction will be appreciated.
Best regards,
Yuwen
Reply to: