Re: LVM and RAID
On Sat, May 26, 2007 at 02:21:54PM +0200, Bruno Costacurta wrote:
> On Thursday 17 May 2007 22:31, Douglas Allan Tutty wrote:
>
> > raid1 mirrors two disks to create one volume. LVM will then divy up
> > that volume. So in the installer, set the disk/partition to use as
> > physical volume for software raid, then configure raid. Then you have
> > md0 which you mark use as physical volume for LVM, then you configure
> > LVM.
> I completed RAID1 installation via installer but without selecting LVM.
> Is it possible to setup LVM once RAID1 is built and system up ?
The problem is that LVM is a layer between the raid and the filesystem.
Short answer: no. Long answer: yes with more work than just
reinstalling.
Doug.
Reply to: