Re: setting-up a dmz
Franck Joncourt <joncourt_franck@yahoo.co.uk> wrote:
| mess-mate wrote:
| > Hi list,
|
| Hi,
|
| > A '/etc/init.d/networking start' give an error about eth2:
| > eth2: ERROR while getting interface flags: No such device.
| >
|
| What about dmesg | grep eth2 ? Does it give to you more information on
| the interface ? Are you sure, eth2 is used by your card. I mean, it may
| be possible that this one is used by another ressource.
|
A dmesg|grep eth give :
eth1: VIA Rhine at 0x1e800, 00:80:c8:ec:92:b5, IRQ 10.
eth1: MII PHY found at address 8, status 0x7809 advertising 05e1
Link 0000.
eth2: RealTek RTL8139 at 0xec00, 00:e0:29:3c:34:bd, IRQ 12
eth2: Identified 8139 chip type 'RTL-8139A'
( remark: 3C59x driver )
eth1: link up, 10Mbps, half-duplex, lpa 0x0000
eth0: setting half-duplex.
ADDRCONF(NETDEV_UP): eth0: link is not ready
eth1: no IPv6 routers present
eth1: link up, 10Mbps, half-duplex, lpa 0x0000
eth1: no IPv6 routers present
Eth0 is normally connected to the modem but had to put the cable t
another router to communicate. This is why the link of eth0 is not
ready.
See also my previous post as a reply to Roberto.
best regards
mess-mate
--
Your domestic life may be harmonious.
Reply to: