Re: USB Generic Drive Storage

[Roby <ElectricalSciences@Adelphia.net>]

Rrodak wrote:

> I have the same problem
> 
> I see the flash storage on usb :
> 
> Bus 003 Device 017: ID 10d6:ff61 Actions Semiconductor Co., Ltd
> Bus 003 Device 001: ID 0000:0000
> Bus 002 Device 004: ID 09da:0006 A4 Tech Co., Ltd Optical Mouse WOP-35 /
> Trust 450L Optical Mouse
> Bus 002 Device 001: ID 0000:0000
> Bus 001 Device 001: ID 0000:0000
> 
> 
> But no devices in /dev/sd..
> 
> I checked the kernel modules, all ok
> 
> only think I see on dmesg is:
> 
> usb 3-6: new high speed USB device using ehci_hcd and address 17
> usb 3-6: configuration #1 chosen from 1 choice
> 
> no more messages...
> somebody an idea?

Does lsusb show a usb_storage module when the device is plugged in?
Here's what I see in dmesg when I plug in my pen drive:
usb 5-6: new high speed USB device using ehci_hcd and address 3
usb 5-6: configuration #1 chosen from 1 choice
Initializing USB Mass Storage driver...
scsi0 : SCSI emulation for USB Mass Storage devices
usb-storage: device found at 3
usb-storage: waiting for device to settle before scanning
usbcore: registered new driver usb-storage
USB Mass Storage support registered.
  Vendor: USB 2.0   Model: Flash Disk        Rev: 1100
  Type:   Direct-Access                      ANSI SCSI revision: 00
SCSI device sda: 1981440 512-byte hdwr sectors (1014 MB)
sda: Write Protect is off
sda: Mode Sense: 43 00 00 00
sda: assuming drive cache: write through
SCSI device sda: 1981440 512-byte hdwr sectors (1014 MB)
sda: Write Protect is off
sda: Mode Sense: 43 00 00 00
sda: assuming drive cache: write through
 sda: sda1
sd 0:0:0:0: Attached scsi removable disk sda
usb-storage: device scan complete