Can't boot after installation
Hello,
i have a new poweredge 1950 with an embedded dell perc 5/i raid
controller
There are 2 disks in it of 72GB and are configured as RAID 1.
I perform a new installation with the debian testing netcd.
Everything goes well, netcard is found, DELL Perc is also found.
When partioning the HDD in the installation menu, these are the details:
SCSI3 (2,0,0) (SDA) -72.7 GB DELL PERC 5/i
i partition the harddisk, continue the installation and install GRUB at
the master boot record.
I reboot after the installation, the GRUB menu is shown and the system
boots.
Then after a while i get:
ALERT!: /DEV/SDA1 does not exist. Dropping to a shell
BusyBox v1.1.3 (Debian 1:1.1.3-2) Built-in shell (ash)
enter 'help' for a list of built-in commands.
/bin/sh: can't access tty; job control turned off.
I also tried in raid 0 without the second disk but it remains the same.
It seems that the installation sees SDA1 but it is nog recognized after
installation.
Can anybody help with this problem please ?
thnx,
Verus.
Disclaimer :
This e-mail is intended for the exclusive use by the person(s) mentioned as recipient(s).
If you are not the intended recipient, please notify us immediately.
This e-mail does not constitute any commitment for Sea-Ro Terminal N.V. or its subsidiaries except when expressly otherwise
agreed in a written agreement between the intended recipient and the originating subsidiaries of Sea-Ro Terminal N.V.
Sea-Ro Terminal and each of its subsidiaries each reserve the right to monitor all e-mail communications through its networks.
This mail has been checked for viruses by Symantec and Trend Micro.
Reply to: