On Sunday 03 September 2006 02:48, glenn mehesy wrote: > I have now been working on this for quite some time and cannot figure > this out. I am trying to get my leadtek tuner with a bttv chip working. > It is an NTSC tuner but debian etch insists on setting the tuner to type > 5 which is a PAL type. Needless to say it does not work. I have tried > putting various options lines in modules.conf using both bttv and tuner > as the module but I keep getting a tuner type 5. I had this card working > in this very system under Fedora Core 4 but an switching all my linux > system to Debian. I tried this same system under sarge but the kernel > was to old and did not support this card so I installed FC4 and it > worked fine when I was able to pass the tuner as an option to the > module. What do I need to do in Etch to pass the tuner=2 option to the > bttv module? I have been googling for the past 10 hours trying > everything I could find but nothing worked. The Etch install is up to > date and I'm running a 2.6.16 686 kernel. Thank you in advance for you > help. Try modprobe -r bttv and modprobe -r tuner then for my TV2000XP Deluxe I would use modprobe bttv card=34 tuner=2 you would need to find the correct card= number for your card. I use the following in a file I created /etc/modprobe.d/tvcard. ## Added by me for proper detection of tuner for TV card options bttv card=34 tuner=2 The loads the bttv module with the correct tuner and card on boot. Stephen -- GPG Pubic Key: http://users.eastlink.ca/~stephencormier/publickey.asc
Attachment:
pgpNhL271qg7Y.pgp
Description: PGP signature