[Date Prev][Date Next] [Thread Prev][Thread Next] [Date Index] [Thread Index]

Re: Fwd: Re: How do I configure Audigy LS Soundcard? ALSA, Etch, 7.1 speaker

steef wrote:

----------  Forwarded Message  ----------

Subject: Re: How do I configure Audigy LS Soundcard? ALSA, Etch, 7.1 speaker
Date: Thursday 29 June 2006 23:58
From: Søren Christensen <severino@ulvedalen.dk>
To: debian-user@lists.debian.org

On Thu, Jun 29, 2006 at 11:13:44PM +0200, Søren Christensen wrote:
On Thu, Jun 29, 2006 at 12:02:17PM +0200, steef wrote:

what kernel are you using? what distro? did you compile the alsa-driver
yourself or are you using the debian_version (built-in in the
2.6.x-kernels)? did you install alsa-utils and/or alsa-base and the
Ok, perhaps I've been a bit sparse on informations.

Kernel: 2.6.15-1-486
Distro: Etch
Soundcard: Sound Blaster Audigy SE
chipset: CA0106

I'm using the alsa-driver from Debian, and I have installed alsa-base
and alsa-utils and alsa-libs

are you using the right chip? if you read the adequate webpages on the
alsa-website you can see that different soundblaster_cards need
different chips. maybe that is the problem?

I myself prefer to compile/install the driver-source (--tar.gz) as root
in/from the directory /usr/source/alsa directly into the kernel. that
works only if you install your kernelheaders and get rid of a small
'lockup-file' within lib/modules/kernel &&.
install as root alsa-libs and alsa-utils as well. on this way I got a -
really good!- sound immediately out of my soundblaster-card. the
on_board intel8x0 sound chip seems to confuse, when turned on *together*
with the soundblaster_card, my audio_programs. that 's the reason i
turned it off.
I think I would make it a module, perhaps because compiling it into the
kernel seems to be to difficult for me, but ...

by the way: did you put snd-ca0106 in /etc/modules ?
no, I will do so, and reboot.

Now I have output. White noise. When there is sound output (for example
from xmms) there is white noise in the speakers. That is, if I un-check
SPDIF-Out in GNOME-alsamixer.

It points in the direction of compiling a new driver. Is there somewhere
a guide to do that?


To UNSUBSCRIBE, email to debian-user-REQUEST@lists.debian.org
with a subject of "unsubscribe". Trouble? Contact listmaster@lists.debian.org


got to go to do some work now. contact you later.



Reply to: