Re: Re: USB flash drive problem(log cont.)
dmesg log cont.=====================================
VFS: Mounted root (cramfs filesystem) readonly.
Freeing unused kernel memory: 148k freed
vesafb: probe of vesafb0 failed with error -6
NET: Registered protocol family 1
Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
ICH4: IDE controller at PCI slot 0000:00:1f.1
PCI: Enabling device 0000:00:1f.1 (0005 -> 0007)
ACPI: PCI interrupt 0000:00:1f.1[A] -> GSI 18 (level, low) -> IRQ 185
ICH4: chipset revision 1
ICH4: not 100% native mode: will probe irqs later
ide0: BM-DMA at 0xffa0-0xffa7, BIOS settings: hda:DMA, hdb:DMA
ide1: BM-DMA at 0xffa8-0xffaf, BIOS settings: hdc:DMA, hdd:DMA
hda: HDS722580VLAT20, ATA DISK drive
hdb: Maxtor 2F040L0, ATA DISK drive
Using anticipatory io scheduler
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
hda: max request size: 1024KiB
hda: 160836480 sectors (82348 MB) w/1794KiB Cache, CHS=16383/255/63, UDMA(100)
/dev/ide/host0/bus0/target0/lun0: p1
hdb: max request size: 128KiB
hdb: Host Protected Area detected.
current capacity is 78125000 sectors (40000 MB)
native capacity is 80293248 sectors (41110 MB)
hdb: 78125000 sectors (40000 MB) w/2048KiB Cache, CHS=65535/16/63, UDMA(100)
/dev/ide/host0/bus0/target1/lun0: p1 p2 < p5 >
hdc: IDE4816CO, ATAPI CD/DVD-ROM drive
hdd: AOPEN DUW1616/ARR, ATAPI CD/DVD-ROM drive
ide1 at 0x170-0x177,0x376 on irq 15
kjournald starting. Commit interval 5 seconds
EXT3-fs: mounted filesystem with ordered data mode.
Adding 1485972k swap on /dev/hdb5. Priority:-1 extents:1
EXT3 FS on hdb1, internal journal
hdc: ATAPI 48X DVD-ROM CD-R/RW drive, 2048kB Cache, UDMA(33)
Uniform CD-ROM driver Revision: 3.20
hdd: ATAPI 48X DVD-ROM DVD-R CD-R/RW drive, 2048kB Cache, UDMA(33)
SCSI subsystem initialized
Capability LSM initialized
e100: Intel(R) PRO/100 Network Driver, 3.0.18
e100: Copyright(c) 1999-2004 Intel Corporation
ACPI: PCI interrupt 0000:01:08.0[A] -> GSI 20 (level, low) -> IRQ 217
e100: eth0: e100_probe: addr 0xff8fd000, irq 217, MAC addr 00:0C:F1:D5:37:E1
Intel 810 + AC97 Audio, version 1.01, 13:45:23 Aug 16 2005
ACPI: PCI interrupt 0000:00:1f.5[B] -> GSI 17 (level, low) -> IRQ 201
PCI: Setting latency timer of device 0000:00:1f.5 to 64
i810: Intel ICH4 found at IO 0xe080 and 0xe400, MEM 0xffa7f800 and 0xffa7f400, IRQ 201
i810: Intel ICH4 mmio at 0xe005b800 and 0xe005d400
i810_audio: Primary codec has ID 2
i810_audio: Audio Controller supports 6 channels.
i810_audio: Defaulting to base 2 channel mode.
i810_audio: Resetting connection 0
i810_audio: Connection 0 with codec id 2
ac97_codec: AC97 Audio codec, id: ALG64 (Unknown)
i810_audio: AC'97 codec 2 supports AMAP, total channels = 2
usbcore: registered new driver usbfs
usbcore: registered new driver hub
USB Universal Host Controller Interface driver v2.2
ACPI: PCI interrupt 0000:00:1d.0[A] -> GSI 16 (level, low) -> IRQ 169
uhci_hcd 0000:00:1d.0: Intel Corp. 82801DB (ICH4) USB UHCI #1
PCI: Setting latency timer of device 0000:00:1d.0 to 64
uhci_hcd 0000:00:1d.0: irq 169, io base 0000e800
uhci_hcd 0000:00:1d.0: new USB bus registered, assigned bus number 1
hub 1-0:1.0: USB hub found
hub 1-0:1.0: 2 ports detected
ACPI: PCI interrupt 0000:00:1d.1[B] -> GSI 19 (level, low) -> IRQ 177
uhci_hcd 0000:00:1d.1: Intel Corp. 82801DB (ICH4) USB UHCI #2
PCI: Setting latency timer of device 0000:00:1d.1 to 64
uhci_hcd 0000:00:1d.1: irq 177, io base 0000e880
uhci_hcd 0000:00:1d.1: new USB bus registered, assigned bus number 2
hub 2-0:1.0: USB hub found
hub 2-0:1.0: 2 ports detected
ACPI: PCI interrupt 0000:00:1d.2[C] -> GSI 18 (level, low) -> IRQ 185
uhci_hcd 0000:00:1d.2: Intel Corp. 82801DB (ICH4) USB UHCI #3
PCI: Setting latency timer of device 0000:00:1d.2 to 64
uhci_hcd 0000:00:1d.2: irq 185, io base 0000ec00
uhci_hcd 0000:00:1d.2: new USB bus registered, assigned bus number 3
hub 3-0:1.0: USB hub found
hub 3-0:1.0: 2 ports detected
usb 2-2: new full speed USB device using address 2
usb 3-1: new low speed USB device using address 2
Initializing USB Mass Storage driver...
scsi0 : SCSI emulation for USB Mass Storage devices
Vendor: eM Model: Bay Reader Rev: 1.00
Type: Direct-Access ANSI SCSI revision: 02
ACPI: PCI interrupt 0000:00:1d.7[D] -> GSI 23 (level, low) -> IRQ 193
ehci_hcd 0000:00:1d.7: Intel Corp. 82801DB (ICH4) USB2 EHCI Controller
Attached scsi removable disk sda at scsi0, channel 0, id 0, lun 0
Vendor: eM Model: Bay Reader Rev: 1.01
Type: Direct-Access ANSI SCSI revision: 02
Attached scsi removable disk sdb at scsi0, channel 0, id 0, lun 1
Vendor: eM Model: Bay Reader Rev: 1.02
Type: Direct-Access ANSI SCSI revision: 02
Attached scsi removable disk sdc at scsi0, channel 0, id 0, lun 2
Vendor: eM Model: Bay Reader Rev: 1.03
Type: Direct-Access ANSI SCSI revision: 02
Attached scsi removable disk sdd at scsi0, channel 0, id 0, lun 3
USB Mass Storage device found at 2
usbcore: registered new driver usb-storage
USB Mass Storage support registered.
usbcore: registered new driver hiddev
input: USB HID v1.10 Mouse [Mitsumi Electric Apple Optical USB Mouse] on usb-0000:00:1d.2-1
usbcore: registered new driver usbhid
drivers/usb/input/hid-core.c: v2.0:USB HID core driver
mice: PS/2 mouse device common for all mice
ts: Compaq touchscreen protocol output
ehci_hcd 0000:00:1d.7: BIOS handoff failed (104, 1010001)
ehci_hcd 0000:00:1d.7: can't reset
ehci_hcd 0000:00:1d.7: init 0000:00:1d.7 fail, -95
ehci_hcd: probe of 0000:00:1d.7 failed with error -95
Linux agpgart interface v0.100 (c) Dave Jones
agpgart: Detected an Intel 845G Chipset.
agpgart: Maximum main memory to use for agp memory: 431M
agpgart: Detected 8060K stolen memory.
agpgart: AGP aperture is 128M @ 0xf0000000
hw_random: RNG not detected
cpci_hotplug: CompactPCI Hot Plug Core version: 0.2
pci_hotplug: PCI Hot Plug PCI Core version: 0.5
pciehp: PCI Express Hot Plug Controller Driver version: 0.4
shpchp: shpc_init : shpc_cap_offset == 0
shpchp: Standard Hot Plug PCI Controller Driver version: 0.4
Real Time Clock Driver v1.12
input: PC Speaker
inserting floppy driver for 2.6.8-2-686
FDC 0 is a National Semiconductor PC87306
parport: PnPBIOS parport detected.
parport0: PC-style at 0x378 (0x778), irq 7, dma 3 [PCSPP,TRISTATE,COMPAT,ECP,DMA]
ndiswrapper version 1.1 loaded (preempt=yes,smp=no)
ndiswrapper: driver wg311v2 (NETGEAR, Inc.,06/17/2004,6.0.5.30) loaded
ACPI: PCI interrupt 0000:01:01.0[A] -> GSI 22 (level, low) -> IRQ 209
ndiswrapper: using irq 209
wlan0: ndiswrapper ethernet device 00:09:5b:bf:86:b2 using driver wg311v2, configuration file 104C:9066:1385:4C00.5.conf
wlan0: encryption modes supported: WEP, WPA with TKIP
NET: Registered protocol family 10
Disabled Privacy Extensions on device c0300140(lo)
IPv6 over IPv4 tunneling driver
NET: Registered protocol family 17
eth0: no IPv6 routers present
wlan0: no IPv6 routers present
ip_tables: (C) 2000-2002 Netfilter core team
ip_conntrack version 2.1 (4026 buckets, 32208 max) - 296 bytes per conntrack
[drm] Initialized i830 1.3.2 20021108 on minor 0: Intel Corp. 82845G/GL[Brookdale-G]/GE Chipset Integrated Graphics Device
mtrr: base(0xf0020000) is not aligned on a size(0x300000) boundary
dmesg log end==============================================
Reply to: