[Date Prev][Date Next] [Thread Prev][Thread Next] [Date Index] [Thread Index]


I have the driver but cannot access the driver. The setup utility for the NIC
gives me:

3c5x9setup.c:v1.00 6/19/2000 Donald Becker (becker@scyld.com)
No interrupt sources are pending.
3c5x9 found at 0x300.
Indication enable is 0000, interrupt enable is 0000.
EEPROM contents:
  Model number 3c509 version 5, base I/O 0x300, IRQ 10, 10baseT port.
  3Com Node Address 00:50:DA:7E:30:2A (used as a unique ID only).
  OEM Station address 00:50:DA:7E:30:2A (used as the ethernet address).
  Manufacture date (MM/DD/YY) 11/11/99, division 6, product WK.
  Options: half duplex, enable linkbeat.
  The computed checksum matches the stored checksum of 7e03.

The enables don't look right, could that be my problem?
-----Original Message-----
From: Ralph Katz <ralph.katz@rcn.com>
To: debian-user@lists.debian.org <debian-user@lists.debian.org>
Date: December 19, 2005 11:57 AM
Subject: Re: NIC PnP

>On 12/18/2005 08:00 PM, Dave Whelan wrote:
>> I can't get my 3c509 working for aliant dsl, does anyone know how I can check
>> whether PnP is enabled on this NIC?
>> Regards,
>> Dave Whelan.
>I have that card working fine on a sarge box with kernel 2.4.27.  From
>the syslog:
>> Dec 19 10:05:57 localhost kernel: isapnp: Scanning for PnP cards...
>> Dec 19 10:05:57 localhost kernel: isapnp: Card '3Com 3C509B EtherLink III'
>> Dec 19 10:05:57 localhost kernel: isapnp: 1 Plug & Play card detected total
>> Dec 19 10:05:57 localhost kernel: eth0: 3c5x9 at 0x220, 10baseT port, address
>> 0 10 4b 15 c4 ed, IRQ 5.
>> Dec 19 10:05:57 localhost kernel: 3c509.c:1.19 16Oct2002 becker@scyld.com
>> Dec 19 10:05:57 localhost kernel: http://www.scyld.com/network/3c509.html
>You should already have the driver:
>$ locate 3c509
>I do have 3c509 listed in /etc/modules.
>To UNSUBSCRIBE, email to debian-user-REQUEST@lists.debian.org
>with a subject of "unsubscribe". Trouble? Contact listmaster@lists.debian.org

Reply to: