usb HP printer etch usblp
Hi,
I had a Wooody that became a Sarge and then bacame an Etch.
The CUPS on it worked very well, I used to use the "printer" module.
Now I see that the module is "usblp" and the problem is that when I send
a job to the printer, it is told to be sent, no error message, but, but,
but,... nothing is printed.
I tried reconfiguring the printer thrgouh the CUPS interface to try
different combinations: no way. Nothing printed. No error message.
What to try? I'm running "testing" now.
Thank you.
--
A powerfull GroupWare, CMS, CRM, ECM: CPS (Open Source & GPL).
Opengroupware, SPIP, Plone, PhpBB, JetSpeed... are good: CPS is better.
http://www.cps-project.org for downloads & documentation.
Free hosting of CPS groupware: http://www.objectis.org.
Reply to: