Re: Software RAID with Debian Installer

[michael@etalon.net]

Quoting Luke Pacholski <lukpac@lukpac.org>:

> I am currently trying to set up software RAID while installing Sarge. I
> have two hard drives, both with one partition "physical volume for RAID",
> as well as a RAID 1 device that uses both. Everything goes fine until I
> try to write the partition table on the RAID device. I get the following
> errors:
>
> [?] Partition disks
> Warning!
> The kernel was unable to re-read the partition table on /dev/md/0 (Invalid
> argument). This means Linux won't know anything nothing about the
> modifications you made until you reboot.  You should reboot your computer
> before doing anything with /dev/md/0.

I think you may want to check your syntax.
It should be /dev/md0


--- Sent via IMP