On Friday 18 March 2005 23:14, Johnny wrote:
Justin Guerin wrote:
On Friday 18 March 2005 22:07, Johnny wrote:
[snip]
Hi Justin
The partitions on the HD is
hda1 linux ex2
hda2 linux swap
Should i have added another partition for booting
Johnny
You might be OK if you add lba32 to your lilo.conf file and re-run lilo.
Alternately, you could install another kernel, and if you get lucky, it
will get placed below the 1024 cylinder limit, and you'll be able to boot
it. You should be able to use the install disk to boot your installed
system. You could also make a boot floppy, and boot from that, if you
wanted to go that route.
On the other hand, you could just reinstall, and make a /boot partition.
Justin Guerin