On Sunday 09 January 2005 06:39 pm, johnc wrote:
Anyone have any more input on this one? (see below)
Here's my lspci output ... the netgear Atheros device is no where to be
seen:
# lspci -b
0000:00:00.0 Host bridge: VIA Technologies, Inc. VT8378 [KM400] Chipset
Host Bridge
0000:00:01.0 PCI bridge: VIA Technologies, Inc. VT8237 PCI Bridge
0000:00:08.0 Network controller: Texas Instruments ACX 111 54Mbps
Wireless Interface
0000:00:10.0 USB Controller: VIA Technologies, Inc. VT82xxxxx UHCI USB
1.1 Controller (rev 80)
0000:00:10.1 USB Controller: VIA Technologies, Inc. VT82xxxxx UHCI USB
1.1 Controller (rev 80)
0000:00:10.2 USB Controller: VIA Technologies, Inc. VT82xxxxx UHCI USB
1.1 Controller (rev 80)
0000:00:10.3 USB Controller: VIA Technologies, Inc. USB 2.0 (rev 82)
0000:00:11.0 ISA bridge: VIA Technologies, Inc. VT8235 ISA Bridge
0000:00:11.1 IDE interface: VIA Technologies, Inc.
VT82C586A/B/VT82C686/A/B/VT823x/A/C PIPC Bus Master IDE (rev 06)
0000:00:11.5 Multimedia audio controller: VIA Technologies, Inc.
VT8233/A/8235/8237 AC97 Audio Controller (rev 50)
0000:00:12.0 Ethernet controller: VIA Technologies, Inc. VT6102
[Rhine-II] (rev 74)
0000:01:00.0 VGA compatible controller: VIA Technologies, Inc. VT8378
[S3 UniChrome] Integrated Video (rev 01)
-John
johnc wrote:
Ok ... that does help ... but further, my question now is: doesn't
lspci report all devices detected, regardless of whatever my kernel's
wireless driver config is like?
I'm not getting anything from lspci about this device. Does that
suggest a more fundamental problem?
-John
Andrea Vettorello wrote:
On Fri, 07 Jan 2005 21:09:53 -0800, johnc <johnc909@comcast.net> wrote:
Hi,
I'm attempting to get my described setup to recognize my Netgear PCI
wireless card (WG311).
I've rebuilt a kernel to include prism54 support ... but the device
doesn't even show up in "lcpci" output.
Any suggestions as to how to go about diagnosing the problem?
You need to know what chipset uses the card, after a quick search
seems that WG311v1 is equipped with an Atheros chipset, the WG311v2
instead uses the TI ACX111 chipset. The quick search point to a
SourceForge page http://acx100.sourceforge.net, but don't know if the
latter works tho.
You can use this page
https://gullfoss2.fcc.gov/prod/oet/cf/eas/reports/GenericSearch.cfm to
know exaclty your HW using the FCCID...
Hope this helps.
Andrea
Atheros might look like this:
0000:00:0a.0 Ethernet controller: Atheros Communications, Inc. AR5212
802.11abg NIC (rev 01)
I don't think yours uses the atheros, I think it uses the other.
0000:00:08.0 Network controller: Texas Instruments ACX 111 54Mbps
Wireless Interface
yours mentions the ACX driver
Andrea mentioned a link:
http://acx100.sourceforge.net