Re: critical install failure, most hardware attempting to use irq 1.

[Levi Waldron <onemorenut@gmail.com>]

On Thu, 11 Nov 2004 11:37:18 +0000, Ben Hutchings
<ben.hutchings@businesswebsoftware.com> wrote:

> Try putting "pci=noacpi" on the boot command line.  If you do that then
> the kernel will use the older PCI BIOS interface to find out the PCI
> configuration and is more likely to get correct answers.  I'm afraid I
> haven't used d-i yet so I don't know quite how you edit the boot command
> line.

Thanks for the reply.  Before I got your reply, I worked around .7 the
problem by  the Woody installer,
which worked fine.  Once I upgraded the kernel, I found that the
2.4.26 kernel had the same problem but the
2.6.7 kernel worked fine.  Perhaps it's the improved acpi support in
the 2.6.7 kernel.