failed debain install
I downloaded the netinstall cd off this url
http://www.debian.org/devel/debian-installer/ports-status
The machine its being installed on is a Supermicro p4sca machine. The
install went smoothly enough but after that things get complicated.
After booting up I get asked my standard post confiurations questions.
As I answer then - the machine reboots(feels almost like a power cycle -
screen goes black, you hear a beep).. Thinking this was a fluke I
rebooted - began entering my info, timezone, user info - etc.. And the
machine reboots agian. The third time I just let it reboot and did
nothing. Still the machine reboots after about 20 to 30 seconds.
I re-burned the cd, re-installed - deleteing the partition table- still
same result - a spontanious reboot during post install setup.. This
machine had been a perfectly happy RH9 box before but decided to switch
to Sarge...
After looking around I found this bug report
http://bugs.debian.org/cgi-bin/bugreport.cgi?bug=248442
After upgrading the bios and dinkering w/ some bios settings - relating
to RAID and SATA I re-installed. Same problem.... I tried combine
mode, sata only, enhanced mode.... no dice.
I've also tried the net install image listed here
http://cdimage.debian.org/pub/cdimage-testing/daily/i386/20040816/
After downloading this image the machine doesn't even recognise the cd
as a bootable cd. Toss in a RH9 or Fedora cd and away it goes.
Interestingly the machine will boot just fine into recovery mode.. If I
boot into recovery mode, then type
'init 3'
the machine reboots shortly their after. Anyone using a Supermicro box
run into this problem or have any luck getting around this?
Reply to: