Help with Woody Install
Hi everyone
I'm trying to install Woody (my first Debian installation) on a HP
Netserver LC 2000. The problem relates to SCSI and RAID detection. When
using the boot "compact" option it detects the SCSI controller (a
Symbios 53C896 according to POST), but not the RAID (a HP NetRAID
adapter 1Si according to POST). When booting with the default
configuration, setup doesn't detect either the SCSI controller or the
RAID controller.
Mandrake 10.0 detects both the RAID and SCSI controllers successfully.
Details of the hardware (from Mandrake) follows:
# cat pci | grep -A 7 "Bus 2, device 6"
Bus 2, device 6, function 0:
SCSI storage controller: LSI Logic / Symbios Logic 53c896 (rev 6).
IRQ 24.
Master Capable. Latency=72. Min Gnt=17.Max Lat=64.
I/O at 0x2000 [0x20ff].
Non-prefetchable 64 bit memory at 0xfd402000 [0xfd4023ff].
Non-prefetchable 64 bit memory at 0xfd400000 [0xfd401fff].
Bus 2, device 6, function 1:
SCSI storage controller: LSI Logic / Symbios Logic 53c896 (#2) (rev 6).
IRQ 25.
Master Capable. Latency=72. Min Gnt=17.Max Lat=64.
I/O at 0x2400 [0x24ff].
Non-prefetchable 64 bit memory at 0xfd402400 [0xfd4027ff].
Non-prefetchable 64 bit memory at 0xfd404000 [0xfd405fff].
# cat scsi/scsi
Attached devices:
Host: scsi0 Channel: 00 Id: 00 Lun: 00
Vendor: MegaRAID Model: LD0 RAID1 8677R Rev: F
Type: Direct-Access ANSI SCSI revision: 02
Host: scsi0 Channel: 04 Id: 05 Lun: 00
Vendor: HP Model: SAFTE; U160/M BP Rev: 1021
Type: Processor ANSI SCSI revision: 02
Host: scsi2 Channel: 00 Id: 08 Lun: 00
Vendor: IBM-ESXS Model: ST373405LW !# Rev: B245
Type: Direct-Access ANSI SCSI revision: 03
# cat scsi/sym53c8xx/1
Chip sym53c896, device id 0xb, revision id 0x6
At PCI address 0000:02:06.0, IRQ 24
Min. period factor 10, Wide SCSI BUS
Max. started commands 510, max. commands per LUN 64
# cat scsi/sym53c8xx/2
Chip sym53c896, device id 0xb, revision id 0x6
At PCI address 0000:02:06.1, IRQ 25
Min. period factor 10, Wide SCSI BUS
Max. started commands 510, max. commands per LUN 64
I have used Google extensively to try to find an answer, but to no avail.
Any suggestions greatly appreciated.
Best regards
Ben
Reply to: