Cannot use APM or ACPI with kernel-image-2.6.6
I'm using the stock kernel-image-2.6.6-i686 and my desktop is unable to
use either APM or ACPI, both of which are built-in.
BIOS has power-saving turned on, with the timer set to 30 minutes. When
booting the stock kernel, I get a message that my BIOS is from before
1999 and I cannot use ACPI. Then I get a message that apm was loaded.
However, even with apm loaded the desktop never goes into power-saving
mode.
So I tried acpi=force, and this is what I get:
Linux version 2.6.6-1-686 (herbert@gondolin) (gcc version 3.3.3 (Debian 20040401)) #1 Wed May 12 14:57:57 EST 2004
<snip>
ACPI: RSDP (v000 PTLTD ) @ 0x000f6ac0
ACPI: RSDT (v001 PTLTD RSDT 0x00000000 PTL 0x01000000) @ 0x040fdd77
ACPI: FADT (v001 DELL KHAN 0x19990921 PTL 0x000f4240) @ 0x040ff78c
ACPI: DSDT (v001 Dell Khan 0x00000000 MSFT 0x01000004) @ 0x00000000
ACPI: PM-Timer IO Port: 0x8008
Built 1 zonelists
Kernel command line: root=/dev/hda6 ro acpi=force
Local APIC disabled by BIOS -- reenabling.
Found and enabled local APIC!
<snip>
ACPI: Subsystem revision 20040326
ACPI: IRQ9 SCI: Level Trigger.
ACPI: Interpreter enabled
ACPI: Using PIC for interrupt routing
ACPI: PCI Root Bridge [PCI0] (00:00)
PCI: Probing PCI hardware (bus 00)
ACPI: PCI Interrupt Routing Table [\_SB_.PCI0._PRT]
ACPI: PCI Interrupt Link [LNKA] (IRQs 3 4 5 7 9 10 *11 12)
ACPI: PCI Interrupt Link [LNKB] (IRQs 3 4 5 7 9 *10 11 12)
ACPI: PCI Interrupt Link [LNKC] (IRQs 3 4 *5 7 9 10 11 12)
ACPI: PCI Interrupt Link [LNKD] (IRQs 3 4 5 7 *9 10 11 12)
<snip>
ACPI: PCI Interrupt Link [LNKD] enabled at IRQ 9
ACPI: PCI Interrupt Link [LNKA] enabled at IRQ 11
ACPI: PCI Interrupt Link [LNKB] enabled at IRQ 10
ACPI: PCI Interrupt Link [LNKC] enabled at IRQ 5
PCI: Using ACPI for IRQ routing
<snip>
ACPI: (supports S0 S1 S5)
How can I configure my kernel to respond to the BIOS calls for either
APM or ACPI?
Thanks,
Dave
----- End forwarded message -----
Reply to: