Re: new install, sound not working (+2 bonus problems)

[Phil Ramey <philramey@pacbell.net>]

Kevin Mark:

Thanks for replying!

Attaching my iRiver to my usb2 card gives me this
output in /var/log/messages, do i need to add a
listing in /etc/fstab or sommat?  i can't mount it,
there's no listing...

Apr 22 22:59:50 box kernel: usb 1-1: new high speed
USB device using address 2
Apr 22 22:59:50 box kernel: scsi0 : SCSI emulation for
USB Mass Storage devices
Apr 22 22:59:51 box kernel:   Vendor: TOSHIBA   Model:
MK2004GAL         Rev: JA02
Apr 22 22:59:51 box kernel:   Type:   Direct-Access   
                  ANSI SCSI revision: 02
Apr 22 22:59:51 box kernel: SCSI device sda: 39063024
512-byte hdwr sectors (20000 MB)
Apr 22 22:59:51 box kernel:  sda:<7>usb-storage:
queuecommand called
Apr 22 22:59:52 box kernel:  sda1
Apr 22 22:59:52 box kernel: Attached scsi disk sda at
scsi0, channel 0, id 0, lun 0

i'm assuming that this is more important than the
lspci listing, because this shows the hardware works
fine...

the fdisk -l thing returns the drive that works along
with:

Disk /dev/hdd: 81.9 GB, 81964302336 bytes
255 heads, 63 sectors/track, 9964 cylinders
Units = cylinders of 16065 * 512 = 8225280 bytes
 
   Device Boot      Start         End      Blocks   Id
 System
/dev/hdd1               2        9964    80027797+   f
 W95 Ext'd (LBA)
/dev/hdd5               2        9964    80027766    b
 W95 FAT32

i can't, however, mount /dev/hdd5, and when i added it
to fstab, it griped about mount points (i put in
/mnt/hdd5 as the mount point, should it be different?)

thanks again!

-Phil Ramey