Re: Re: Can't "make xconfig" for kernel 2.6.test9

[Ramasubramanian Ramesh <rramesh@ti.com>]

> On Sun, Jan 11, 2004 at 05:25:45PM -0600, Ramasubramanian Ramesh wrote:
> | Hi,
> |
> | I seem to have a problem doing make xconfig on the kernel-2.6.test9
> | sources
> | obtained from sarge. I suspect qt installation problem based on the ld
> | output. But you can see from apt-get output (at the end) libqt-dev is
> | installed.
> 
> From /usr/share/doc/kernel-source-2.6.0/debian.README.gz
>     [...] make xconfig also requires [...]
>     libqt3-mt-dev and g++ >= 3.0 for the new 2.6 kenel versions [...]
> 
> I suggest trying to isntall libqt3-mt-dev instead of libqt-dev.  I
> would also recommend getting the final release, instead of a
> pre-release test version.
> 

According to libqt-dev package, it replaces libqt3 and conflicts libqt3. Also there are no libqt3 in
testing/sarge. So I installed libqt-dev. In any case I think something is wrong with libqt-dev in
testing and I have asked the debian owner of this package and waiting for a response. 

I read the debian.README.gz for 2.6.test9 and it only talks about ncurses-dev and tkX.X-dev and I
have both yet no make xconfig. I have now turned my attention to make menu config and it will have
to do until I know if there is something wrong with my libqt-dev or some other install.

BTW, there are no 2.6.0 or 2.6.1 in testing as far as I can tell. I did apt-get update still the
above two do not show up (there is test11 though). 

Thanks for helping. 

Ramesh