Re: ifconfig eth0 shows errors building
On Mon, 2004-01-05 at 20:26, mike wrote:
> Hi,
>
> When I run ifconfig eth0, my "errors" section keeps growing.
> Here's an example output from # ifconfig eth0
>
> UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
> RX packets:1334682 *****errors:65273 *****dropped:0 overruns:1
> frame:78897
> TX packets:640316 errors:0 dropped:0 overruns:0 carrier:23
> collisions:1729
> RX bytes:678692267 (647.2 MiB) TX bytes:144369628 (137.6 MiB)
>
> I've highlighted the concerned area with *****
> The error number keeps growing if I run ifconfig eth0 over and over.
> Any ideas on how to trouble shoot this?
> I have the same nic in as eth1 and it doesn't show any errors.
>
> Thanks,
> Mike
>
>
>
> Open WebMail Project (http://openwebmail.org)
> Debian Project (http://www.debian.org)
>
Looks like bad cabling or a bogged down net to me, notice that the
collision-count is pretty high out too.
My guess is you have a bad nic or bad cabling/bogged net...
Sturla
Reply to: