Re: Intel 10/100 VE and eepro100
Unfortunately, I tried 2.4bf with no luck. It includes eepro100, which
fails, but not e100 (as far as I could tell).
Thanks though.
----------------------------------------------------------------------
Andrew J Perrin - http://www.unc.edu/~aperrin
Assistant Professor of Sociology, U of North Carolina, Chapel Hill
clists@perrin.socsci.unc.edu * andrew_perrin (at) unc.edu
On Tue, 16 Sep 2003, Rich Puhek wrote:
>
> Andrew Perrin wrote:
>
> > Greetings-
> >
> > Setting up a new computer (an IBM NetVista) that has an Intel 10/100 VE
> > adapter built in, I'm unable to use a net install.
> >
> > What I did was to burn a CD with the vanilla kernel setup, and boot to it.
> > I can boot fine, but when I try to load the eepro100 module, I get
> > "init_module: no such device" or "init_module: device or resource busy".
> > Without that, I can't start the network, so I can't do the net install.
> >
> > Any advice on this? I thought eepro100 would work, even if e100 is
> > probably the ultimate better choice. e100 is available only as source, so
> > I can't use it to do the net install (right?).
> >
>
> I thought that the 2.4bf image had both? If so, you should be able to do
> the net install that way. Might want to give that a try...
>
> --Rich
>
> _________________________________________________________
>
> Rich Puhek
> ETN Systems Inc.
> 2125 1st Ave East
> Hibbing MN 55746
>
> tel: 218.262.1130
> email: rpuhek@etnsystems.com
> _________________________________________________________
>
>
Reply to: