Intel 10/100 VE and eepro100
Greetings-
Setting up a new computer (an IBM NetVista) that has an Intel 10/100 VE
adapter built in, I'm unable to use a net install.
What I did was to burn a CD with the vanilla kernel setup, and boot to it.
I can boot fine, but when I try to load the eepro100 module, I get
"init_module: no such device" or "init_module: device or resource busy".
Without that, I can't start the network, so I can't do the net install.
Any advice on this? I thought eepro100 would work, even if e100 is
probably the ultimate better choice. e100 is available only as source, so
I can't use it to do the net install (right?).
/proc/pci shows the adapter as PCI device 8086:1039, IO=0x300, IRQ=20.
Thanks for any advice (including that I should just download complete
ISO's and forget the net install).
Andy
----------------------------------------------------------------------
Andrew J Perrin - http://www.unc.edu/~aperrin
Assistant Professor of Sociology, U of North Carolina, Chapel Hill
clists@perrin.socsci.unc.edu * andrew_perrin (at) unc.edu
Reply to: