Re: can't get Network working after setting up new kernel
On Fri, 2003-05-09 at 15:43, jeremy wrote:
> I just set up a new kernel 2.4.20-ck6. and I cannot get my network going.
>
> I can ping 127.0.0.1
>
> -and my syslog shows the exact same messages reguarding the ethernet both
> show:
>
> May 9 20:18:17 debian kernel: 8139too Fast Ethernet driver 0.9.24
> May 9 20:18:17 debian kernel: PCI: Setting latency timer of device 00:0d.0 to
> 6
> 4
> May 9 20:18:17 debian kernel: eth0: RealTek RTL8139 Fast Ethernet at
> 0xce81a000, 00:02:3f:31:ed:86, IRQ 10
> May 9 20:18:17 debian kernel: eth0: Identified 8139 chip type 'RTL-8139B'
> May 9 20:18:17 debian kernel: eth0: Setting 100mbps full-duplex based on
> auto-negotiated partner ability 45e1.
>
>
>
> -and here is my /etc/network/inferfaces:
>
> /etc/network/interfaces -- configuration file for ifup(8), ifdown(8)
>
> # The loopback interface
> auto lo
> iface lo inet loopback
>
> # The first network card - this entry was created during the Debian
> installation
> auto eth0
> iface eth0 inet dhcp
>
> I can not ping anyother IP and can not connect to any servers.
> what could be wrong?
What about:
$ /sbin/ifconfig
and (if you use dhclient):
$ sudo grep dhclient /var/log/syslog
--
+---------------------------------------------------------------+
| Ron Johnson, Jr. mailto:ron.l.johnson@cox.net |
| Jefferson, LA USA http://members.cox.net/ron.l.johnson |
| |
| The purpose of the military isn't to pay your college tuition |
| or give you a little extra income; it's to "kill people and |
| break things". Surprisingly, not everyone understands that. |
+---------------------------------------------------------------+
Reply to: