[Date Prev][Date Next] [Thread Prev][Thread Next] [Date Index] [Thread Index]

Re: Can't access 1 IP address on Lan



hi ya curtis

do my silly question is.. where is the machine called 10.0.1.1 
that does not reply to pings ??
	- if you know where 10.0.1.1 is... do the same set of commands
	again ( route -nv, ifconfig -v, ipchains -L, etc

	- the 10.0.1.1 machine should be able to ping itself
	and should be ble to ping the local LAN and outside world

i am not 100% sure... but you might wanna turn off "null ipchains" rules
or at least have it pass all up  .. 

am assuming this is NOT the firewall and if it is... you're missing
all of  the  fw rules

c ya
alvin


On Thu, 10 Oct 2002, Curtis wrote:

> > hi ya curtis
> >
> > what is the output of
> >
> > root# route -nv
> Debian3800:~# route -nv
> Kernel IP routing table
> Destination     Gateway         Genmask         Flags Metric Ref    Use
> Iface
> 10.0.1.0        0.0.0.0         255.255.255.0   U     0      0        0 eth0
> 0.0.0.0         10.0.1.254      0.0.0.0         UG    0      0        0 eth0
> 
> > root# ifconfig -v
> Debian3800:~# ifconfig -v
> eth0      Link encap:Ethernet  HWaddr 00:10:A4:D2:DE:91
>           inet addr:10.0.1.5  Bcast:10.0.1.255  Mask:255.255.255.0
>           UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
>           RX packets:30267475 errors:0 dropped:0 overruns:0 frame:0
>           TX packets:157542 errors:0 dropped:0 overruns:0 carrier:0
>           collisions:0 txqueuelen:100
>           RX bytes:3128132587 (2.9 GiB)  TX bytes:40244900 (38.3 MiB)
>           Interrupt:11 Base address:0x4800
> 
> lo        Link encap:Local Loopback
>           inet addr:127.0.0.1  Mask:255.0.0.0
>           UP LOOPBACK RUNNING  MTU:16436  Metric:1
>           RX packets:26119 errors:0 dropped:0 overruns:0 frame:0
>           TX packets:26119 errors:0 dropped:0 overruns:0 carrier:0
>           collisions:0 txqueuelen:0
>           RX bytes:14695650 (14.0 MiB)  TX bytes:14695650 (14.0 MiB)
> 
> >
> > root# ipchains -L
> Debian3800:~# iptables -L
> Chain INPUT (policy ACCEPT)
> target     prot opt source               destination
> 
> Chain FORWARD (policy ACCEPT)
> target     prot opt source               destination
> 
> Chain OUTPUT (policy ACCEPT)
> target     prot opt source               destination
> 
> >
> > root# ping 10.0.1.1
> > ( a local ping of itself should always work even w/o a cable )
> Debian3800:~# ping 10.0.1.1
> PING 10.0.1.1 (10.0.1.1): 56 data bytes
> (nothing else)
> 
> >
> > am assuming you didn't manually turn off ping replies on the one host
> Right. Other computers can ping it.
> 



Reply to: