10 based eepro acting weird
Having a funny one here:
The eepro card stops functioning, for hours on end. Then suddenly it
would start responding again. In the logfile, just before it stopped
functioning:
Sep 11 09:21:43 buzzer kernel: eth0: XMT status = 0xffff8841
And then before it started responding:
Sep 12 04:08:03 buzzer kernel: eth0: set Rx mode to 1 address.
Netsaint is telling me it has been up for 4 hours now. Yesterday it
stopped working while I was ssh'ing into the PC, and I think it has
something to do with that. HTTP is fine (but it is a very low load PC).
I've talked with someone on IRC, and he says he's dmesg says something
about a work-around being enabled for this card. I have the stock 2.4.18
on that PC, it's an old Pentium. But I don't have a msg regarding a
workaround.
--
Danie Roux *shuffle* Adore Unix
Reply to: